Newsletter Subscribe
Enter your email address below and subscribe to our newsletter

Aim for the vital zone in the lower third of the chest cavity, just behind the front shoulder - about 4-6 inches behind the front leg crease on a broadside deer.

Sighting in a multi-pin sight means setting each pin to a specific distance by shooting groups and adjusting windage and elevation until every pin hits point-of-aim at its range.

Each pin on a multi-pin sight corresponds to a set distance - pick the pin matching your target's range, place it on your aim point, and execute a smooth release.

Installing an arrow rest means mounting it to the riser's threaded hole, aligning it to your arrow's height and center-shot position, and securing it - about 15-30 minutes with an Allen wrench.

A single-pin slider requires setting the pin to your target's exact yardage before every shot, unlike multi-pin sights with pre-set distance marks.

A D-loop is a small braided-cord loop tied to your bowstring that gives your release aid a consistent attachment point - here's how to tie one properly.

Gap shooting uses the arrow point as a deliberate reference to judge distance, while instinctive aiming relies on subconscious hand-eye coordination - here's how the two traditional methods compare.

Installing a peep sight means using a bow press to relieve string tension, separating the strands at the right spot, inserting the peep, and serving it in place - about 15-30 minutes.